Misc Links
Forum Archive
News Archive
File DB
 

Solder your own USB power connector cable for LC-Displays
Posted by Red Squirrel on July 04th 2004



I received a lot of questions about how to move the power supply
of the LC displays to the outer part of the case.
Here you have two possibilities - you could lead the 4-pin-plug
of the main power source through a free slot shield out of the case,
or simply follow this little instruction and solder your own adaptor,
which uses the 5 V power supply of the USB port and supplies the LCD.


View article at ocinside



(Due to past abuse from spammers you must be a registered forum member to post comments, and must be logged in)


corner image

This site best viewed in a W3C standard browser at 800*600 or higher
Site design by Red Squirrel | Contact
© Copyright 2017 Ryan Auclair/IceTeks, All rights reserved