Misc Links
Forum Archive
News Archive
File DB
 

quoted-printable encoded unnecessarily
Posted by News-Bot on September 27th 2006



Given the no frills appearance of these modules, I had fairly low expectations for overclocking, and pretty much any gain was going to exceed them... Without touching the timings at all, and with only an increase in voltage from 1.80V to 1.85V, this kit was able to climb to DDR2-960 speeds. Although unstable at 1000 MHz, I did get into Windows, and can tell that with a bit of tweaking, and perhaps some more voltage, these modules could handle it. Another thing that might help with overclocking is some sort of cooling. Many may find heatspreaders to be all about presentation, but slapping a set on these memory modules might be worth the money!

View article at bigbruin.com



(Due to past abuse from spammers you must be a registered forum member to post comments, and must be logged in)


corner image

This site best viewed in a W3C standard browser at 800*600 or higher
Site design by Red Squirrel | Contact
© Copyright 2017 Ryan Auclair/IceTeks, All rights reserved